Skip to main content

Remote User Menu & Panel Print Menu

95 Remote User Menu​

951 Remote User Codes​

The Remote User Codes menu is used to program remote user codes for remote users 1 to 7. Remote users can access their system with SmartLink700 (an up/download application) at an off-site or remote location. Each remote user code is required to be 4-6 digits in length. The digit 0 is not allowed. New codes must be verified in order to be accepted.

952 Remote User Names​

Remote User Names; user names enable more detailed information to be displayed in the system log.

953 Remote User Options​

Remote User Options; each remote user can be assigned a number of options. These are explained as follows:

  • Call back enables the panel to make a call to one of its pre-programmed remote user phone numbers in the event that the Digi has received an incoming call from a number that it recognises.
note

Please verify that caller ID is enabled on the phone line that you intend to use this feature on and that it functions properly.

  • With Rem. Set set to NO, SmartLink700 is prevented from remotely setting (or arming) the panel.

  • With Rem. Unset set to NO, SmartLink700 is prevented from remotely unsetting the panel.

954 Remote User Phones​

Remote User Phones; each remote user can have their phone number programmed into the system. This number must be programmed to allow the system...

  1. Recognise Caller ID in order to call back SmartLink700
  2. Recognise Caller ID in order to answer an incoming call and finally...
  3. Call SmartLink700 as a result of the 0*3 quick key option.

96 Panel Print Menu​

warning

Printing via the Serial Port ceased from version 3.2.0 onwards.

961 Print Engineer Log​

With the Print Engineer Log command, the contents of the Engineer Log can be printed out using a serial printer connected to J5 on the Quantum 70 and SP1 or SP2 on the SW-1070 control panel.

962 Printer Options​

Printer Options; there are 2 options.

1 Real Time Log​

One is Real Time Log which, if selected, prints out each item as it is logged to the Engineer Log.

2 Use Form Feed​

The other is Use Form Feed; the last page of a job is sometimes not visible because it is still physically within the printer. By selecting Use Form Feed the printer advances the paper to the top of the next page.